Switch Part Number KJD17B / 120V Problem

Thought I had a problem with the start switch soon after I got my model CT129N mill. The switch would not engage and stay in "ON" position. I contacted my local Busy Bee store and they passed me off to head office. I received a call from a tech very quickly with a solution. He said "There is a micro-switch on the front safety guard". I can't wait to get home and check it out. If this is true, then there should have been something about this in the owners manual. Well it was the clear acrylic guard in front of the spindle. As soon as I move it in place it worked. I rechecked the slim owners manual and couldn't see anything in reference to this.

Next Mod - Universal joints and connecting rods

I want to use universal joints and connecting rods to access the y-Axis gib locks under the table.

Mounting tool makers vice to table.

My solution for mounting my tool makers vice.

Improved Gib lock knobs on X-Axis. Modification.

I hated the levers that were stock on all the gib locks.

These knobs are of sufficient diameter to provide enough torque to do the job and still clear the dovetail of the Y-axis. I believe the are better than stock for sure.

Gib locks on the Y axis.

Not happy with these gib locks, I want to replace them with a small knurled knob.

Closer shot of modified roaster pan under the mill.

Got this pan at a restaurant supply store. Its pretty thick sheet steel construction and very well made.

Rare-Earth magnet is great for holding chuck key.

Those rare earth magnets make for a handy place to store the chuck key.

Mill mounted on bench with roaster pan chip tray.

I hope to add edging to cover the sharp areas I had to cut out.

My new CT129N mill fresh out of the crate.